User's Manual
BTS Configuration – continued
JAN 2002
7-23
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
DRAFT
Procedure to Set IP Address
You must set an IP address on the unit before you can begin an LMF
Ethernet (LAN) session. Follow the instructions in Table 7-8 to set the
IP address.
Table 7-8: Procedure to Set IP Address
Step Action
1 Enter the following command to check the ethernet IP address:
sc300>ether getip
Observe the following typical response (if the IP address was not set):
COMMAND ACCEPTED: ether getip
Current IP ADDRESS: 0.0.0.0
2 Enter the following command to check the ethernet gateway address:
sc300>ether getgw
Observe the following typical response (if the IP address was not set):
COMMAND ACCEPTED: ether getgw
GW address: 0.0.0.0
3 Enter the following command to check the ethernet netmask value:
sc300>ether getnm
Observe the following typical response (if the IP address was not set):
COMMAND ACCEPTED: ether getnm
NETMASK: 0.0.0.0
4 If the IP address is set, then you are finished with this procedure. If you must set the IP address,
then proceed with steps 5 through 7.
NOTE
The default LMF IP address is 128.0.0.2.
5 Enter the following command to set the IP address:
sc300>ether setip 128.0.0.2
The system will display the following output:
COMMAND ACCEPTED: ether setip 128.0.0.2
THESE ARE THE BYTES READ IN: 128.0.0.2
SETTING IP: 128.0.0.2
Completed flashing of IP address
CONFIRM NEW IP: 128.0.0.2
SETTING Ethernet Address: 8:0:80:0:0:2
Completed flashing of Ether address
CONFIRM NEW Ethernet Address: 8:0:80:0:0:2
New parameters will take affect after next reset.
. . . continued on next page
7