User's Manual

BTS Configuration – continued

DRAFT

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

JAN 2002

7-22

Procedure to Establish an MMI

Communication Session

For those procedures which require MMI communication between the

CDMA LMF and the BTS, follow the procedures in Table 7-7 to initiate

the communication session.

If an LMF session is in progress, logout of the LMF prior

to establishing an MMI communication session. Refer to

steps 1 and 2 of the “Remove LMF” procedure in

Table 7-54.

NOTE

Table 7-7: Procedure to Establish an MMI Communication Session

Step Action

1 Connect the CDMA LMF computer to the BTS. Refer to the “Connecting the LMF to the BTS”

procedure in this chapter.

2 Start the named HyperTerminal connection for MMI sessions by double clicking on its Windows

desktop shortcut.

NOTE

If a Windows desktop shortcut was not created for the MMI connection, access the connection from

the Windows Start menu by selecting:

Programs > Accessories > Hyperterminal > HyperTerminal > <Named HyperTerminal

Connection (e.g., MMI Session)>

Once the connection window opens, establish MMI communication with the BTS FRU by pressing

the CDMA LMF computer Enter key until the prompt identified in the applicable procedure is

obtained.

Every command is entered at the SC300> prompt unless otherwise specified.