User's Manual

Shut Down & Restore BTS Signaling continued
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
8-12
Table 8-3: Procedure to Restore Signaling Operations
Step Action
7 View the congestion control parameters for all carriers equipped for the sector by entering the
following command at the prompt:
omc000000>display sector<bts#><sector#> congestconf
Observe the following typical system display response:
CARRIER NEWCALL REG AGG
(bts#sector#carrier#) SET ALARMFLAG ALARMFLAG ALARMFLAG ANALOGREDIRECT GLOBALREDIRECT
––––––––––––––––––––––– ––– ––––––––– ––––––––– ––––––––– –––––––––––––– ––––––––––––––
30014 1 ENABLE ENABLE ENABLE DISABLE ENABLE
8
NOTE
In this step, you will change the value of the Global Service Redirection Flag
(GLOBALREDIRECT) in the congestion control parameters so that the Global Service Redirect
Message is only broadcast on the sector paging channel when there is traffic congestion in the
sector.
Enter the following command at the prompt:
omc000000>edit sector<bts#><sector#> congestconf !
The system will prompt you to enter each control parameter value one at a time. Skip through the
prompts until you get to the following:
<globalredirect> , enter disable
(This will revert the Global Service Redirect Message to congestion control.)
The system will display the values of the control parameters. Verify that only the
GLOBALREDIRECT value changed.
omc000000>Accept [yes/no]?
Enter Y to accept the change.
Now the Global Service Redirection Message will only be sent over the sector paging channels
when there is traffic congestion in the sector.
9 Display the status of the MAWI at the BTS by entering the following command at the prompt:
omc000000>display bts<bts#> status
Observe the following typical system response:
DEVSYNC
Config Calibration Calibration ISO RELATED
DEVICE CBSC STATUS Data Data Sync STATE
–––––––––––––––––– –––– –––––– –––– –––– ––––––– ––––––––––––
BTS300 1 INS n/a n/a UNLOCKED UNLOCKED
BTSSPAN3001 1 INS n/a n/a n/a n/a
BTSLINK3001 1 INS n/a n/a n/a n/a
LPA3001 1 OOS_PARENT n/a n/a n/a n/a
MDM3001 1 PRECUT n/a n/a n/a n/a
MAWI3001 1 INS GOOD GOOD GOOD KEYED
. . . continued on next page
8