User's Manual

Shut Down & Restore BTS Signaling – continued
JAN 2002
8-11
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
DRAFT
Table 8-3: Procedure to Restore Signaling Operations
Step Action
5
* IMPORTANT
In this step, use the values recorded in step 2 of the shut down signaling functions table to answer
the prompts for the EDIT SECTOR REDIRECT command; except for record type enter 2.
NOTE
This step shows the entry of initial standard values which is consistent with the original example;
except record type must be 2. Your entries may be different.
Restore the values of all redirect parameters by entering the following command at the prompt:
omc–000000>edit sector–<bts#>–<sector#> redirect !
The system will prompt you to enter each command parameter one at a time. Answer the prompts
in the following order (Note that the following specified values are consistent with the original
example. Yours may be different):
<accolc0> Enter N, <accolc1> Enter N, ... <accolc15> enter N
<returniffail> , enter N
<recordtype> , enter 2
<expe tedsid>
<expecte
d
s
id
> , enter 0
<ignorecdma> , enter N
<sysordering> , enter custom
<rotatetimer> , enter 4
The system will display the command that will be sent. Verify the command syntax.
omc–000000>Accept [yes/no]?
Enter Y to accept the command.
6 View the status of the sector signaling redirect parameters to verify that the sector is ready for
maintenance.
omc–000000>display sector–<bts#>–<sector#> redirect
Ensure that the values in the system display response match the values input by the operator in
step 5 (see example below).
Access Overload Class Redirect Flags ROTATE
CARRIER ID RETURN 0 0 0 0 0 0 0 0 0 0 1 1 1 1 1 1 TIMER RECORD EXP IGNORE SYS
(bts–sector–carrier) IF FAIL 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 (SEC) TYPE SID CDMA ORDERING
–––––––––––––––––––– ––––––– – – – – – – – – – – – – – – – – ––––– –––– ––– –––– ––––––––
CARRIER–1–1–1 N N N N N N N N N N N N N N N N N 4 2 0 N CUSTOM
. . . continued on next page
8