User's Manual

Connect LMF to BTS
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
7-6
Overview
This procedure gives instructions to connect the LMF to the BTS.
LMF to BTS Connection
The LMF is connected to the MMI/LMF connector on the diagnostic
access area.
The LMF serial port, or PCMCIA (Personal Computer Memory Card
International Association) Serial Adapter provides the connection
between the LMF and the MMI/LMF connector located on the
diagnostic access area.
There are three different methods to connect the LMF to the BTS: serial
port to DB9, Ethernet via Ethernet hub, and Ethernet via crossover
connection.
Procedure to Connect LMF to
BTS via Serial Port Connection
Connect the LMF to the BTS. Refer to Figure 7-6, Figure 7-10, and
Table 7-2.
Figure 7-6: Serial to DB9 BTS to LMF connection
DB9
DB9
LMF
DB9 TO DB9 CABLE
CONNECT 15 TO 9–PIN MMI TO SERIAL
CONNECTOR TO MMI/ENET SYSTEM PORT
CONNECT TO
PCMCIA SERIAL I/O
OR SERIAL I/O PORT
7