User's Manual

FRU Tools and Materials

DRAFT

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

JAN 2002

1-18

Introduction

The following is a list of the FRUs for the Microcell unit and a list of the

tools and materials necessary to perform the FRU installation and

removal procedures:

List of FRUs

The following is a list of FRUs for the unit:

1. Site I/O Junction Box with Primary Surge Suppressor – Kit T450AE

2. Site I/O Junction Box without Primary Surge Suppressor – Kit

T450AA

3. RGPS Head – Kit T472AP

4. Short Duration Battery – Kit T348AE

5. Primary Surge Suppressor – Kit T449AA

6. AC Installation Box – Kit T449AB

MicroCell

1. A Band BTS with HSO – Kit SG1478AA

2. A Band BTS without HSO – Kit SG1479AA

3. B Band BTS with HSO – Kit SG1486AA

4. B Band BTS without HSO – Kit SG1487AA

5. Solar Cover – Kit T451AA

6. Fin Cover – Kit T389AB

Required Tools and Materials

to Perform FRU Procedures

Table 1-4 lists the required tools and materials to perform the FRU

installation procedures.

Table 1-4: Required Tools and Material to Perform FRU Procedures

Hand Tools Materials Power Tools

T30 Torx tamper bit, 1/4–in. hex Applicable FRU None Required

T20 Torx tamper bit, 1/4–in. hex Installation handles

Torque driver wrench, 1/4–in hex

female drive, 0–10 N–M

(optional)

13 mm torque wrench

5/16 breakaway torque wrench

13/16 breakaway torque wrench