User's Manual
Installation Tools and Materials – continued
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
1-12
Required Tools and Materials
for Installing the Mounting
Bracket on a Rack
The following tools and materials in Table 1-2 are required to properly
and safely install the mounting bracket on a rack.
Table 1-2: Required Tools and Materials for Rack Mounting
Hand Tools Materials Power Tools
T30 Torx tamper bit, 1/4–in. hex MicroCell Mounting Kit No Power Tools Required
Torque driver wrench, 1/4–in. hex
female drive, 0–10 N–M
Four machine screws 12–24
5/8-in. self tapping (customer
supplied)
Chalk or marker to mark
location on rack
(customer supplied)
electrical tape
(customer supplied)
Required Tools and Materials
for Installing the Mounting
Bracket on a Concrete Wall
The following tools and materials in Table 1-3 are required to properly
and safely install the mounting bracket on a concrete wall.
Table 1-3: Required Tools and Materials for Concrete Wall Mounting
Hand Tools Materials Power Tools
T30 Torx tamper bit, 1/4–in hex metal shim material Hilti wall drilling rig
15/16-in. (23.8 mm) socket, a ratchet
wrench, and an 18-in. (45.7 cm)
breaker bar
Hilti anchors (for each
bracket)
Hilti DCM 18–14 metric bit
safety glasses MicroCell Mounting Kit shop vacuum
chalk for marking outline on wall electrical tape
tape measure
(customer supplied)
4-ft (1.22 m) bubble level
rubber mallet
ear plugs
dust mask
1