User's Manual

List of Figures – continued
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
viii
Figure 6-16: DC Power Cabling Details 6-26. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-17: Antenna Cabling Details for One MicroCell Unit 6-27. . . . . . . . . . . . .
Figure 6-18: Antenna Cabling for Two MicroCells 6-28. . . . . . . . . . . . . . . . . . . . . .
Figure 6-19: Antenna Cabling for Three MicroCells 6-28. . . . . . . . . . . . . . . . . . . . .
Figure 6-20: Antenna Cabling for Four MicroCells 6-29. . . . . . . . . . . . . . . . . . . . . .
Figure 6-21: Installation of Third and Fourth Antenna Lightning Arrestors 6-31. . .
Figure 6-22: Antenna Cabling Details for MicroCell Equipped with
Primary Surge Suppressor 6-31. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-23: Antenna Cabling for Two MicroCells Equipped with
Primary Surge Suppressor 6-32. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-24: Antenna Cabling for Three MicroCells Equipped with
Primary Surge Suppressor 6-32. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-25: Antenna Cabling for Four MicroCells Equipped with
Primary Surge Suppressor 6-33. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-26: MIB Cabling for Two Units 6-36. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-27: MIB Cabling for Three Units 6-37. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-28: MIB Cabling for Four Units 6-37. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-29: Lock Positions on Primary Surge Suppressor 6-40. . . . . . . . . . . . . . . .
Figure 6-30: Location of AC Power Breakers on Primary Surge Suppressor 6-41. .
Figure 6-31: Front Solar Cover 6-41. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 7-1: Front Solar Cover 7-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 7-2: Location of AC Power Breakers Inside Primary Surge Suppressor 7-3
Figure 7-3: Location of AC and DC Power Breakers 7-3. . . . . . . . . . . . . . . . . . . . .
Figure 7-4: How To Remove The Diagnostic Access Cover 7-4. . . . . . . . . . . . . . .
Figure 7-5: Detail Location of the Diagnostic Access Area 7-5. . . . . . . . . . . . . . . .
Figure 7-6: Serial to DB9 BTS to LMF connection 7-6. . . . . . . . . . . . . . . . . . . . . .
Figure 7-7: Ethernet BTS to LMF Connection Using an Ethernet Hub 7-7. . . . . . .
Figure 7-8: Ethernet Crossover Cable and Adapter Wiring 7-8. . . . . . . . . . . . . . . .
Figure 7-9: Ethernet BTS to LMF Connection Using Crossover Cable or
Adapter 7-8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 7-10: 15–Pin MMI/LMF Serial Connector 7-9. . . . . . . . . . . . . . . . . . . . . . .
Figure 7-11: Communications Test Set Timing Signal Detail
(Advantest R3465) 7-12. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 7-12: R3267 Communications Test Set Timing Signal Detail 7-14. . . . . . . .
Figure 7-13: Communications Test Set Timing Signal Detail
(CyberTest, HP 8935, and HP 8921) 7-15. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 7-14: Agilent 10 MHz Reference Connections 7-16. . . . . . . . . . . . . . . . . . . .
Figure 7-15: Agilent E4406A/E4432B Communications Test Set
Timing Signal Detail 7-17. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 7-16: LMF to Test Equipment Connection 7-18. . . . . . . . . . . . . . . . . . . . . . .