User's Manual Part 3

Automated Acceptance Test Procedure Overview continued
DRAFT
SC4812ET BTS Optimization/ATP CDMA LMF
Apr 2001
4-4
Waveform Quality (rho)
This test verifies that the transmitted Pilot channel element digital
waveform quality (rho) exceeds the minimum specified value in
ANSIJ_STD019. Rho represents the correlation between actual and
perfect CDMA modulation spectrum. A rho value of 1.0000 represents
100% (or perfect correlation).
Pilot Time Offset
The Pilot Time Offset is the difference between the CDMA analyzer
measurement interval (based on the BTS system time reference) and the
incoming block of transmitted data from the BTS (Pilot only, Pilot
Gain = 262, PN Offset = 0).
Code Domain Power
This test verifies code domain power levels, which have been set for all
ODD numbered Walsh channels, using the OCNS command. This is
done by verifying that the ratio of PILOT divided by OCNS is equal to
10.2 + 2 dB, and, that the noise floor of all EVEN numbered OFF
Walsh channels measures
< 27 dB .
Frame Error Rate
The Frame Error Rate (FER) test verifies RX operation of the entire
CDMA Reverse Link using all equipped MCCs assigned to all
respective sector/antennas. The test verifies the BTS sensitivity on all
traffic channel elements currently configured on all equipped MCCs at
an RF input level of 119 dBm (or 116 dBm if using TMPC). Follow
the procedure in Table 4-1 to perform any ATP test.
The STOP button can be used to stop the testing process.
NOTE
Table 4-1: ATP Test Procedure
Step Action
1 Select the BBX2(s) and MCC(s) to be tested.
2 From the Tests menu, select the desired test.
3 Select the appropriate carrier(s) (carrier bts# sector# carrier#) displayed in the Channels/Carrier
pick list.
To select multiple items, hold down the <Shift> or <Ctrl> key while making the selections.
4 Type the appropriate channel number in the Carrier n Channels box.
The default channel number displayed is determined by the CdmaChans[n] number in the cbscn.cdf
file for the BTS.
5 Click OK.
6 Follow the cable connection directions as they are displayed.
7 Click Save Results or Dismiss to close the status report window.
If Dismiss is used the test results will not be saved in the test report file.
4