User's Manual Part 3

Alarms Testing – continued
Apr 2001
3-89
SC4812ET BTS Optimization/ATP — CDMA LMF
DRAFT
Figure 3-16: Location of Connector J8 on the Meter Alarm Panel
OFF
VOLT
VOLT
–
+
TEST POINTS
AMPS
–
+
TEST POINTS
AMP
PWR
ON
RED
YEL
BLK
OR
VIOLENT
OR BRWN
Terminal Block
FRONT VIEW
J9
J1
J2
J3
J8
J5
J6
J4
REAR VIEW
Terminal Block
J1 J2
Not
Used
J6
J5
J3
Rear Connector Panel
J4
FW00245
Before Leaving the site
Table 3-56 gives instructions on what to check before leaving the site.
Table 3-56: Check Before Leaving the Site
Step Action
1 Verify that ALL battery circuit breakers (for occupied shelves) are CLOSED (pushed in).
2 Verify that the Heat Exchanger is running.
3 Verify that the Meter Alarm Panel and TCP modules are switched ON.
4 Verify that the Battery Test Switch on the Meter Alarm Panel is in the OFF position.
5 Verify that no alarm conditions are being reported (with all doors closed).
3