User's Manual Part 3

Index – continued
DRAFT
SC4812ET BTS Optimization/ATP — CDMA LMF
Apr 2001Index-6
Test Equipment Setup, 3-42
Test Equipment Setup Calibration for TX Bay Level
Offset, 3-56, F-14
Test Equipment Setup Chart, 3-43
Test equipment setup RF path calibration, 3-63
Test Set Calibration, 3-50
Timing Reference Cables, 1-8
Transmit TX path audit, 3-67
Transmit TX path calibration, 3-64
Transmit/Receive Module TRX, 1-27
Troubleshooting
DC Power Problems, 6-17
Span Problems no control link, 6-28
TX and RX Signal Routing, 6-18
Troubleshooting CSM Checklist, 6-11
TX
antenna VSWR, test data sheets, A-15, A-16
BLO test data sheets, A-8, A-13
TX & RX Path Calibration, 3-59
TX and RX Frequency vs Channel , D-2
TX and RX Signal Routing, C–CCP Backplane
Troubleshooting, 6-18
TX Audit Test, 3-68
TX Bay Level Offset and TX ATP test equipment
setup calibration, 3-55
TX Code Domain Power ATP, 4-9
tx fine adjust, E-1
TX Mask Verification, spectrum analyzer display,
illustration, 4-6
TX Output Acceptance Tests – Introduction
Code domain power, 4-4
Pilot time offset, 4-4
Spectral purity TX mask, 4-3
Waveform Quality (rho), 4-3
TX Path Calibration, 3-60
TX Pilot Time Offset ATP, 4-8
TX Spectral Purity Transmit Mask ATP, 4-5
TX Waveform Quality (rho) ATP, 4-7
TX/RX OUT Connections, 4-2
txmask test, 4-5
U
Updating CDMA LMF Files, 5-1
UTP, LMF to BTS connection, 3-17
V
Verify, test equipment used, test data sheets, A-1
Virtual BTS, 1-13
W
Walsh channels, 4-9
When to optimize
Ancillary – table, B-1
BTS, B-1
inter–frame cabling, B-2
X
XCVR Backplane Troubleshooting, 6-13
Xircom Model PE3–10B2, LMF to BTS connection,
3-17