User's Manual Part 3

Index – continued
DRAFT
SC4812ET BTS Optimization/ATP — CDMA LMF
Apr 2001Index-2
Calibration
data file calibration, BLO, 3-61
In–Service, G-5
power meter, Gigatronics 8542B, F-19
Calibration Audit failure, 6-7
calibration data file, description of, BLO, 3-61
Cannot communicate to Communications Analyzer,
6-3
Cannot communicate to Power Meter, 6-2
Cannot Download DATA to any device card, 6-4
Cannot ENABLE device, 6-5
Cannot Log into cell–site, 6-2
Cannot perform carrier measurement, 6-9
Cannot perform Code Domain Noise Power
measurement, 6-9
Cannot perform Rho or pilot time offset
measurement, 6-8
Cannot perform Txmask measurement, 6-8
CCD, 1-18
CCP, shelf 1 – all inclusive TX ATP test outline,
primary, 4-12
CDF
site configuration, 3-2
site equipage verification, 3-3
site type and equipage data information, 2-1
CDMA
allocation diagram for the North American, cellular
telephone frequency spectrum, D-4
optimization/ATP test matrix, B-1
cdpower test, 4-9
Cell Site
equipage verification, 2-1
types configuration, 3-2
Cell Site Data File. See CDF
Cell Site Field Engineer CFE, 1-1
Channel Service Unit, 3-4
CIO, 1-18
CIO Connectors, 6-14
CLI, 1-2
Code Domain Power and Noise Floor Levels, 4-10
Code Domain Power/Noise, 4-9
Communication test set, rear panel, F-2, F-4
Communications System Analyzer, 1-8
Communications system analyzer , 1-8
Connecting test equipment to the BTS, 3-42
Connector Functionality
Backplane, Troubleshooting, 6-13
Troubleshooting, Backplane, 6-13
Copy CAL Files From Diskette to the CBSC, 5-2
Copy CDF Files from CBSC, 3-12
Copy Files from LMF to Diskette, 5-1
Copying CAL files from CDMA LMF to the CBSC,
5-1
Copying CAL files to the CBSC, 5-2
CSM, 1-18
and LFR primary functions, 3-32
CSM frequency verification, 3-34
CSM LED Status Combinations, 6-22
Customer I/O, 1-19
CyberTest Communication Analyzer, 1-8
D
DC Power Pre–test (BTS Frame), 2-7
DC Power Problems, C–CCP Backplane
Troubleshooting, 6-17
DC/DC Converter LED Status Combinations, 6-21
Detailed, optimization/ATP test matrix, B-2
Digital Control Problems, 6-15
C–CCP Backplane Troubleshooting, 6-15
Digital Multimeter, 1-9
Directional Coupler, 1-9
Download
BTS system software, 3-3
MGLI, 3-27
Non–MGLI2 Devices, 3-28
Download BLO Procedure, 3-65
Download/Enable MCCs, 3-31
Duplexer/Directional Coupler DDC, 1-17, 1-18, 1-19,
1-20, 1-28
E
E1, isolate BTS from the E1 spans, 3-4