User's Manual Part 3

Apr 2001
SC4812ET BTS Optimization/ATP — CDMA LMF
DRAFT
Index-1
Index
Numbers
10BaseT/10Base2 Converter, 1-7
10BaseT/10Base2 converter, LMF to BTS
connection, 3-17
2–way Splitter, 1-10
A
Acceptance Test Procedures ATP , 1-1
Acronyms, 1-11
ACTIVE LED
GLI, 6-24
MCC, 6-26
Alarm and Span Line Cable Pin/Signal Information,
3-6
ALARM LED, GLI, 6-24
Alarm Monitor window, 3-82
Alarm Reporting Display, 3-82
All inclusive, TX ATP test outline – CCP shelf 1,
primary, 4-12
All tests fail on a single antenna, Troubleshooting,
RFDS, 6-20
AMR, 1-18
Ancillary frame, when to optimize, B-1
Applying AC Power, 2-5
ATP
generate failure report, 4-12
generate report, 4-12
test matrix/detailed optimization, B-2
ATP – Code Domain Power, 4-9
ATP – Frame Error Rate (FER), 4-11
ATP – Pilot Time Offset, 4-8
ATP – Spectral Purity Transmit Mask, 4-5
ATP – Waveform Quality (rho), 4-7
ATP Report, 4-12
ATP Test Procedure, 4-4
B
Basic Troubleshooting Overview, 6-1
Battery Charge Test (Connected Batteries), 2-10
Battery Discharge Test, 2-10
Bay Level offset calibration failure, 6-6
BBX, gain set point vs SIF output considerations, C-1
BBX2, 1-18
BBX2 Connector, 6-14
BBX2 LED Status Combinations, 6-26
BTS
Ethernet LAN interconnect diagram, 3-19
LMF connection, 3-9, 3-17
system software download, 3-3
when to optimize, B-1
BTS Cabinet, 1-26
BTS Site Setup for Acceptance Test Procedures, 3-69
Create CAL File, 3-70
C
C–CCP Backplane Troubleshooting, Procedure, 6-14
C–CCP shelf, 1-18
Cables Connection for 10 MHz Signal and GPIB ,
F-2, F-4
Calibrate BLO, 3-59
Calibrating Cables, 3-53
Calibrating Test Cable Setup, PCS Interface
HP83236B, F-10
Calibrating Test Equipment, 3-53