User's Manual Part 2

Test Set Calibration – continued

DRAFT

Apr 2001

3-51

SC4812ET BTS Optimization/ATP — CDMA LMF

Selecting Test Equipment

Use LMF Options from the Options menu list to select test equipment

automatically (using the autodetect feature) or manually.

Prerequisites

A Serial Connection and a Network Connection tab are provided for

test equipment selection. The Serial Connection tab is used when the

test equipment items are connected directly to the CDMA LMF

computer via a GPIB box (normal setup). The Network Connection tab

is used when the test equipment is to be connected remotely via a

network connection.

Ensure the following has been completed before selecting test

equipment:

 Test equipment is correctly connected and turned on.

 CDMA LMF computer serial port and test equipment are connected to

the GPIB box.

Manually Selecting Test

Equipment in a Serial

Connection Tab

Test equipment can be manually specified before, or after, the test

equipment is connected. CDMA LMF does not check to see if the test

equipment is actually detected for manual specification.

Table 3-22: Selecting Test Equipment Manually in a Serial Connection Tab

Step Action

1 From the Options menu, select LMF Options. The LMF Options window appears.

2 Click on the Serial Connection tab (if not in the forefront).

3 Select the correct serial port in the COMM Port pick list (normally COM1).

4 Click on the Manual Specification button (if not enabled).

5 Click on the check box corresponding to the test item(s) to be used.

6 Type the GPIB address in the corresponding GPIB address box. Recommended Addresses

13=Power Meter

18=CDMA Analyzer

7 Click on Apply. (The button will darken until the selection has been committed.)

NOTE

With manual selection, CDMA LMF does not detect the test equipment to see if it is connected and

communicating with CDMA LMF.

8 Click on Dismiss to close the test equipment window.