User's Manual Part 2

Download the BTS – continued

DRAFT

SC4812ET BTS Optimization/ATP — CDMA LMF

Apr 2001

3-28

All devices in a BTS must have the same R–level ROM

and RAM code before the optimization and ATP

procedures can be performed. If a newly installed BTS is to

be upgraded, the optimization and ATPs should be

accomplished with the prior code load. Then the site

should be upgraded by the CBSC. The optimization and

ATP procedures do not have to be performed again after

the upgrade. If a replacement device needs to be used in a

BTS with a later version of software, the device ROM code

can be changed with use of the LMF before the

optimization and ATPs are performed for the BTS. Refer to

the Download ROM Code section.

WARNING

Table 3-13: Download and Enable MGLI2

Step Action

1 Select Util>Tools>Update Next Load function to ensure the Next Load parameter is set to the correct

code version level.

2 Download code to the primary MGLI2 by clicking on the MGLI2.

– From the Device pull down menu, select Download Code.

A status report confirms change in the device(s) status.

– Click OK to close the status window. (The MGLI2 should automatically be downloaded with data

and enabled.)

3 Download code and data to the redundant MGLI2 but do not enable at this time.

Download Code and Data to

Non–MGLI2 Devices

Non–MGLI2 devices can be downloaded individually or all equipped

devices can be downloaded with one action. Follow the procedure in

Table 3-14 to download code and data to the non–MGLI2 devices.

When downloading multiple devices, the download may

fail for some of the devices (a time out occurs). These

devices can be downloaded separately after completing the

multiple download.

NOTE