User's Manual Part 2

Using CDMA LMF – continued

DRAFT

Apr 2001

3-25

SC4812ET BTS Optimization/ATP — CDMA LMF

Table 3-10: BTS GUI Logout Procedure

Step Action

3 Click on Yes or press the Enter key to confirm logout. You are returned to the Login tab.

NOTE

If a logout was previously performed on the BTS from a CLI window running at the same time as the

GUI, a Logout Error popup message will appear stating the system should not log out of the BTS.

When this occurs, the GUI must be exited and restarted before it can be used for further operations.

4 If a Logout Error popup message appears stating that the system could not log out of the Base Station

because the given BTS is not logged in, click OK and proceed to step 5.

5 Select File > Exit in the window menu bar, click Ye s in the Confirm Logout popup, and click Yes in

the Logout Error popup which appears again.

6 If further work is to be done in the GUI, restart it.

Logging Out of a BTS from the CLI Environment

Follow the procedure in Table 3-10 to logout of a BTS when using the

CLI environment.

Table 3-11: BTS CLI Logout Procedure

Step Action

* IMPORTANT

If the BTS is also logged into from a GUI running at the same time and further work must be done

with it in the GUI, proceed to step 2.

Logout of a BTS by entering the following command:

logout bts–

<bts#>

A response similar to the following will be displayed:

LMF>

12:22:58.028 Command Received and Accepted

Command=logout bts–33

12:22:58.028 Command Received and Accepted

12:22:58.028 Command Successfully Completed

REASON_CODE=”No Reason”

2 If desired, close the CLI interface by entering the following command:

exit

A response similar to the following will be displayed before the window closes:

Killing background processes....