Manual

Recovery From BTS Router Boot to rommon68P09258A31–A
Oct 2003
1X SCt 4812T BTS Optimization/ATP
J-69
Table J-15: Simple Recovery from BTS Router rommon Boot
Step Action
3 Note the IOS filename, and enter the following to begin recovery to an IOS boot:
boot slot0:IOS_filename
Where IOS_filename = the filename of the IOS noted in step 2, above.
A successful IOS re–boot operation will result in display of a response which begins and ends similar
to the following:
rommon 2 > boot slot0:mwr1941–i–mz.122–8.MC2a.bin
program load complete, entry point: 0x80008000, size: 0xb2a0
program load complete, entry point: 0x80008000, size: 0x6b99ac
Self decompressing the image :
################################################################### [OK]
Smart Init is enabled
smart init is sizing iomem
ID MEMORY_REQ TYPE
00031A 0X005F3C00 MWR1941 Mainboard
0X000F3BB0 public buffer pools
0X00211000 public particle pools
TOTAL: 0X008F87B0
.
.
.
Press RETURN to get started!
4 If the router successfully reboots with the IOS, proceed to step 7.
5 If the router does not reboot with the IOS, perform the following:
5a Scroll the HyperTerminal display down until the directory display from step 2, above, is visible.
5b Compare the IOS filename from the directory display with the filename entered in performing step
3, above.
5c If the filename was typed incorrectly, repeat step 3, using care to type the filename correctly.
6 If the router does not reboot with the IOS after typing the filename correctly, proceed to Table J-16 and
perform the extended recovery procedure.
. . . continued on next page
J