Manual

Verifying IOS Canned Version of the CF Memory Card68P09258A31–A

Oct 2003

1X SCt 4812T BTS Optimization/ATP

J-17

Table J-4: Set LMF Computer NIC IP Address and Create a Default TFTP Directory

Step Action

1 Start the computer.

2 Login and allow the computer to boot to the desktop.

3 Depending on the installed operating system, from the Windows Start menu, select one of the

following:

S Win2000: Settings > Network and Dial–up Connections

S Win98: Settings > Control Panel and double–click Network.

4 Perform one of the following as applicable for the installed operating system:

S For Win2000, in the list of displayed connections, locate the Local Area Network connection for the

NIC to be used for BTS router Ethernet communication.

S For Win98, in the Configuration tab of the Network dialog box, locate the TCP/IP connection for

the installed NIC.

– If TCP/IP does not appear in the displayed list of installed network components, refer to the

operating system documentation and install TCP/IP.

5 Perform one of the following as applicable for the installed operating system:

S For Win2000, highlight the connection for the NIC and right click the highlighted connection, and

select Properties from the pop–up menu.

S For Win98:

– Highlight the TCP/IP NIC connection in the displayed list of installed network components.

– Click the Properties button.

– Skip to step 8.

6 For Win2000 , in the Local Area Connection Properties dialog box which appears, if Internet

Protocol (TCP/IP) is not showing in the Components checked are used by this connection: listbox,

refer to the operating system documentation and install TCP/IP.

7 For Win2000, if the checkbox next to the Internet Protocol (TCP/IP) entry is not checked, click in the

box to check it.

8 Perform one of the following:

S Win2000: Highlight the Internet Protocol (TCP/IP) entry, and click on the Properties button below

the Components checked are used by this connection: listbox.

S Win98: From the tabs displayed in the TCP/IP Properties dialog box which opens, select the IP

Address tab if it is not at the front.

. . . continued on next page