User's Manual Part 2

Download the BTS – continued

DRAFT

SCt4812T CDMA BTS Optimization/ATP

Mar 2001

3-28

R9 RAM code must NOT be downloaded to a device that

has R8 ROM code and R8 RAM code must NOT be

downloaded to a device that has R9 ROM code. All

devices in a BTS must have the same R–level ROM and

RAM code before the optimization and ATP procedures

can be performed. If a newly installed R8 BTS is to be

upgraded to R9, the optimization and ATPs should be

accomplished with the R8 code. Then the site should be

upgraded to R9 by the CBSC. The optimization and ATP

procedures do not have to be performed again after the R9

upgrade. If a replacement R8 device needs to be used in a

R9 BTS, the device ROM code can be changed with use of

the LMF before the optimization and ATPs are performed

for the BTS. Refer to the Download ROM Code section. A

R9 device can not be converted back to a R8 device in the

field without Motorola assistance.

WARNING

Table 3-12: Download and Enable MGLI2

 Step Action

1 Select Util>Tools>Update Next Load function to ensure the Next Load parameter is set to the

correct code version level.

2 Download code to the primary MGLI2 by clicking on the MGLI2.

– From the Device pull down menu, select Download Code.

A status report confirms change in the device(s) status.

– Click OK to close the status window. (The MGLI2 should automatically be downloaded with

data and enabled.)

3 Download code and data to the redundant MGLI2 but do not enable at this time.