User's Manual Part 2

Preparing the LMF – continued

Mar 2001

3-11

SCt4812T CDMA BTS Optimization/ATP

DRAFT

Table 3-5: Creating a Named Hyperlink Connection for MMI Connection

Step Action

1 From the Windows Start menu, select:

Programs>Accessories

2 Perform one of the following:

 For Win NT, select Hyperterminal and then click on HyperTerminal

 For Win 98, select Communications, double click the Hyperterminal folder, and then double click

on the Hyperterm.exe icon in the window that opens.

NOTE

 If a Location Information Window appears, enter the required information, then click Close.

(This is required the first time, even if a modem is not to be used.)

 If a You need to install a modem..... message appears, click NO.

3 When the Connection Description box opens:

– Type a name for the connection being defined (e.g., MMI Session) in the Name: window.

– Highlight any icon preferred for the named connection in the Icon: chooser window.

– Click OK.

NOTE

For LMF configurations where COM1 is used by another interface such as test equipment and a

physical port is available for COM2, select COM2 to prevent conflicts.

From the Connect using: pick list in the Connect To box displayed, select the RS–232 port to be used

for the connection (e.g., COM1 or COM2 (Win NT) – or Direct to Com 1 or Direct to Com 2 (Win

98), and click OK.

5 In the Port Settings tab of the COM# Properties window displayed, configure the RS–232 port

settings as follows:

 Bits per second: 9600

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: None

6 Click OK.

7 Save the defined connection by selecting:

File>Save

8 Close the HyperTerminal window by selecting:

File>Exit

9 Click Yes to disconnect when prompted.

. . . continued on next page