User's Manual Part 2

Preparing the LMF – continued

DRAFT

SCt4812T CDMA BTS Optimization/ATP

Mar 2001

3-8

Table 3-3: LMF Operating System Installation

 ActionStep

5 Follow the instructions displayed on the Setup screen.

* IMPORTANT

First Time Installations:

– Install U/WIN (First)

– Install Java Runtime Environment (Second)

– Install LMF Software (Third)

– Install BTS Binaries (Fourth)

– Install/Create BTS Folders (Fifth)

Any time you install U/WIN, you must install the LMF software because the installation of the

LMF modifies some of the files that are installed during the U/Win installation. Installing U/Win

over–writes these modifications.

NOTE

There are multiple binary image packages for installation on the CD–ROM. When prompted,

choose the load that corresponds to the switch release that you currently have installed. Perform

the Device Images install after the WinLMF installation.

If applicable, a separate CD ROM of BTS Binaries may be available for binary updates.

Copy CDF Files from CBSC

Before the LMF can execute the optimization/ATP procedures for the

BTS, the correct bts-#.cdf and cbsc-#.cdf files must be

obtained from the CBSC and put in a bts-# folder in the LMF

notebook. This requires copying the CBSC CDF files to a DOS

formatted diskette, and using the diskette to install the CDF file in the

LMF.

Follow the procedure in Table 3-4 to obtain the CDF files from the

CBSC and copy the files to a diskette. For any further information, refer

to the CDMA LMF Operator’s Guide (Motorola part number

68P64114A78) or the LMF Help screen..

If the LMF has ftp capability, the ftp method can be used to

copy the CDF files from the CBSC.

On Sun OS workstations, the unix2dos command can be

used in place of the cp command (e.g., unix2dos

bts–248.cdf bts–248.cdf). This should be done using a

copy of the CBSC CDF file so the original CBSC CDF file

is not changed to DOS format.

NOTE

. . . continued on next page