User's Manual

Optimization Manual: Scope and Layout

May 2000

1-1

SC 4812T CDMA BTS Optimization/ATP

Scope of This Document

This document provides information pertaining to the optimization and

audit tests of Motorola SC 4812T Base Transceiver Subsystem (BTS)

equipment frames equipped with trunked high–power Linear Power

Amplifiers (LPAs) and their associated internal and external interfaces.

This document assumes the following prerequisites:

 The BTS frames and cabling have been installed per the BTS Frame

Installation Manual – 68P09226A18, which covers the physical “bolt

down” of all SC series equipment frames, and the

SC 4812T CDMA BTS

Installation Manual –68P64113A87 which covers BTS specific cabling

configurations.

In most applications the same test procedure is used for all equipment

variations. However, decision break points are provided throughout the

procedure when equipment specific tests are required.

As the CDMA Local Maintenance Facility (LMF)

capability comes on–line, applicable LMF based

procedures will be incorporated. Eventually, only the

CDMA LMF platform will be supported as the

recommended customer method of interfacing with and

servicing the SC series BTS equipment.

IMPORTANT

We at Motorola Technical Education & Documentation have strived to

incorporate into this document the many suggestions and inputs received

from you, the customer, since the inception of the SC product line. At

the same time, we have tried to insure that the scope of the document

targets both the novice and expert site technician and engineer with

the information required to successfully perform the task at hand. If

in some areas, the manual seems to cover the test in too much detail (or

not enough detail) we hope you will keep this in mind.