User's Manual

C–CCP Backplane Troubleshooting – continued
May 2000
6-19
SC 4812T CDMA BTS Optimization/ATP
No DC Voltage (+5, +6.5, or +15 Volts) to a Specific GLI2,
BBX2, or Switchboard
Perform the procedure in Table 6-23 to troubleshoot a DC input voltage
to GLI2, BBX2, or Switchboard failure.
Table 6-23: No DC Input Voltage to any C–CCP Shelf Module
Step Action
1 Verify steps in Table 6-22 have been performed.
2 Inspect the defective board/module (both board and backplane) connector for damage.
3 Replace suspect board/module with known good board/module.
TX and RX Signal Routing
Problems
Perform the procedure in Table 6-24 to troubleshoot TX and RX signal
routing problems.
Table 6-24: TX and RX Signal Routing Problems
Step Action
1 Inspect all Harting Cable connectors and back–plane connectors for damage in all the affected board
slots.
2 Perform steps in the RF path troubleshooting flowchart in this manual.
6