User's Manual

Prepare to Leave the Site – continued
May 2000
5-5
SC 4812T CDMA BTS Optimization/ATP
Table 5-4: Set BTS Span Parameter Configuration
Step Action
2 Enter the following MMI command to display the current MGLI/SGLI Span Rate:
config ni linkspeed <cr>
Observe that the acknowledgement is displayed similar to the output shown below.
Option Linkspeed Option
56 56k (default for T1_1 and T1–3 systems)
64 64k (default for all other span configurations)
default Use the default speed appropriate for the span type
The linkspeed parameter in flash is set to use the 64k
Currently the link is running at 64
The actual rate is 0.
3 If the current MGLI2/SGLI2 span rate does not display the correct choice, set the span rate by entering
the following MMI command to configure the span rate to match what is needed:
config ni linkspeed <option> <cr><cr> { where option = 64, 56, default }
* IMPORTANT
After the “span set” and “config ni linkspeed” commands are executed, the affected MGLI2/SGLI2
board MUST be reset and re–loaded for changes to take effect.
Although defaults are shown, always consult site specific documentation for span type and rate used at
the site.
4 Press the RESET button on the GLI2 for changes to take effect.
5 This completes the site specific BTS Span setup for this GLI. Move the MMI cable to the next SGLI2
and repeat steps 1 through 4 for ALL MGLI2/SGLI2 boards.
6 Terminate the Hyperterm session and disconnect the LMF from the MGLI/SGLI.
5