User's Manual

Prepare to Leave the Site – continued

SC 4812T CDMA BTS Optimization/ATP

May 2000

5-2

Reset All Devices

Reset all devices by cycling power before leaving the site. The

configuration data and code loads could be different from data and code

on the LMF. By resetting all devices, the CBSC can load the proper data

and code when the span is active again.

Follow the procedure in Table 5-2 as required to bring all processor

modules from the OOS to INS mode.

Have the CBSC/MM bring up the site and enable all

devices at the BTS.

IMPORTANT

Table 5-2: Enabling Devices

 Step Action

1 On the LMF, select the device(s) you wish to enable.

NOTE

The MGLI and CSM must be INS before an MCC can be put INS.

2 Click on Device from the menu bar.

3 Click on Enable from the Device menu.

A status report window is displayed.

NOTE

If a BBX2 is selected, a Transceiver Parameters window is displayed to collect keying

information.

Do not enable the BBX2.

4 Click OK to close the Transceiver Parameters window.

A status report window displays the status of the device.

5 Click OK to close the status report window.

The selected devices that successfully change to INS change color to green.