User's Manual

RFDS Setup and Calibration – continued

SC 4812T CDMA BTS Optimization/ATP

May 2000

3-72

RFDS Parameter Settings

The bts-#.cdf file includes RFDS parameter settings that must

match the installed RFDS equipment. The paragraphs below describe the

editable parameters and their defaults. Table 3-38 explains how to edit

the parameter settings.

 RfdsEquip – valid inputs are 0 through 2.

0 = (default) RFDS is not equipped

1 = Non-Cobra/Patzer box RFDS

2 = Cobra RFDS

 TsuEquip – valid inputs are 0 or 1

0 = (default) TSU not equipped

1 = TSU is equipped in the system

 MC1....4 – valid inputs are 0 or 1

0 = (default) Not equipped

1 = Multicouplers equipped in RFDS system

(9600 system RFDS only)

 Asu1/2Equip – valid inputs are 0 or 1

0 = (default) Not equipped

1 = Equipped

 TestOrigDN – valid inputs are ’’’ (default) or a numerical string up to

15 characters. (This is the phone number the RFDS dials when

originating a call. A dummy number needs to be set up by the switch,

and is to be used in this field.)

Any text editor supporting the LMF may be used to open

any text files to verify, view, or modify data.

NOTE

. . . continued on next page