User's Manual

Download the BTS – continued
May 2000
3-27
SC 4812T CDMA BTS Optimization/ATP
Enable MCCs
This procedure configures the MCC and sets the “tx fine adjust”
parameter. The “tx fine adjust” parameter is not a transmit gain setting,
but a timing adjustment that compensates for the processing delay in the
BTS (approximately 3 s).
Follow the procedure in Table 3-15 to enable the MCCs.
The MGLI2, and primary CSM must be downloaded and
enabled (IN–SERVICE ACTIVE), before downloading and
enabling the MCC.
IMPORTANT
*
Table 3-15: Enable MCCs
 Step Action
1 Verify the MCC(s) have been downloaded with code (Yellow, OOS–RAM) and data.
2 Select the MCCs to be enabled or from the Select pulldown menu choose All MCCs.
3 From the Device menu, select Enable
A status report confirms change in the device(s) status.
4 Click on OK to close the status report window.
Enable Redundant GLIs
Follow the procedure in Table 3-16 to enable the redundant GLI(s).
Table 3-16: Enable Redundant GLIs
 Step Action
1 Select the target redundant GLI(s).
2 From the Device menu, select Enable.
A status report window confirms the change in the device(s) status and the enabled GLI(s) is
green.
3 Click on OK to close the status report window.
3