User Manual

Map Title Goes Here – continued

08/15/2000

3-29

SC 4812ETL BTS Optimization/ATP

PRELIMINARY

The Ethernet LAN A and B cables must be installed on

each frame/enclosure before performing this test. All other

processor board LAN connections are made via the

backplanes.

IMPORTANT

Table 3-12: Pinging the Processors

Step Action

1 From the Windows desktop, click the Start button and select Run.

2 In the Open box, type ping and the GLI2 IP address (for example, ping 128.0.0.2).

NOTE

128.0.0.2 is the default IP address for the GLI2 in field BTS units.

3 Click on the OK button.

4 If the targeted module responds, text similar to the following is displayed:

Reply from 128 128.0.0.2: bytes=32 time=3ms TTL=255

If there is no response the following is displayed:

Request timed out

If the GLI2 fails to respond, it should be reset and re–pinged. If it still fails to respond, typical

problems are shorted BNC to inter-frame cabling, open cables, crossed A and B link cables, or the

GLI2 itself.