User Manual

Index – continued
PRELIMINARY
SC 4812ETL BTS Optimization/ATP
08/15/2000Index-2
RX sensitivity/frame error rate, 4-8
system software download, 3-3
when to optimize, B-1
BTS Frame Erasure Rate. See FER
BTS Log In Procedure, GUI, 3-22
BTS login
CLI environment, 3-24
General, 3-21
GUI environment, 3-22
BTS Logout
CLI environment, 3-26
GUI environment, 3-25
BTS Site Setup for Acceptance Test Procedures, 3-74
Create CAL File, 3-75
bts–nnn.cal File, 3-16
C
Cables Connection for 10 MHz Signal and GPIB ,
F-2, F-4
Calibrate BLO, 3-64
Calibrating Cables, 3-58
Calibrating Test Cable Setup, PCS Interface
HP83236B, F-10
Calibrating Test Equipment, 3-58
Calibration
data file calibration, BLO, 3-66
power meter, Gigatronics 8542B, F-19
Calibration Audit failure, 6-8
calibration data file, description of, BLO, 3-66
Cannot communicate to Communications Analyzer,
6-3
Cannot communicate to Power Meter, 6-2
Cannot Download DATA to any device card, 6-4
Cannot ENABLE device, 6-5
Cannot Log into cell–site, 6-2
Cannot perform carrier measurement, 6-10
Cannot perform Code Domain Noise Power
measurement, 6-10
Cannot perform Rho or pilot time offset
measurement, 6-9
Cannot perform Txmask measurement, 6-9
cbsc folder, 3-17
CCD, 1-18
CDF
site configuration, 3-2
site equipage verification, 3-3
site type and equipage data information, 2-1
CDMA
allocation diagram for the North American, cellular
telephone frequency spectrum, D-4
optimization/ATP test matrix, B-1
subscriber mobile radiotelephone, optional test
equipment, 1-10
cdma Folder, 3-15
Cell Site
equipage verification, 2-1
types configuration, 3-2
Cell Site Data File. See CDF
Channel Service Unit, 3-4
CIO, 1-18
CIO Connectors, 6-15
Clock Sync Module. See CSM
Code domain power/noise floor
acceptance test, 4-15
analyzer display, 4-17
code Folder, 3-17
Communication test set, rear panel, F-2, F-4
Communications test set. See Test equipment
Connect BTS T1 spans, 5-5
Connecting test equipment to the BTS, 3-47
Connector Functionality
Backplane, Troubleshooting, 6-14
Troubleshooting, Backplane, 6-14
Control, TX output verification, 4-3
Copy CBSC CDF Files to the LMF, 3-11
Copying CAL files from CDMA LMF to the CBSC,
5-1
Copying CAL files to the CBSC, 5-1
CSM, 1-18
and LFR primary functions, 3-37
CSM frequency verification, 3-39
CSM LED Status Combinations, 6-23
Customer I/O, 1-20