Installation Instructions

Power, Ground and Battery Cabling for Sites Equipped With Optional

Primary Surge Suppressor

– continued

DEC 2000

5-15

SCt300 BTS Hardware Installation, ATP and FRU Procedures

PRELIMINARY

Table 5-6: Procedure to Install Earth Ground Cable on a BTS

Equipped with Optional Primary Surge Suppressor

Step Action

1 Route cable A (ground cable) from the ground lug on the

mounting bracket to the Primary Surge Suppressor.

2 Connect cable A to the GND connector 1–4 on the Primary

Surge Suppressor.

Table 5-7: Procedure to Install AC Input Cable(s) on a BTS Equipped

with Optional Primary Surge Suppressor

Step Action

1 Connect the customer–supplied AC input cable (cable T) to

the customer defined AC power source. Refer to Table 5-3 for

wiring information.

2 Verify all connections of cable T with an ohmmeter prior to

routing the cable.

3 Route cable T via 1–in. conduit from the customer defined

AC power source to the breaker terminals inside the Primary

Surge Suppressor. Refer to Figure 5-12.

4 Route the AC Input Power Cable (cable S – Motorola part

number 3087854C02) from the Carrier 1–4 AC Output

connector on the Primary Surge Suppressor to the unit

location(s).