Installation Instructions

BTS Configuration

DEC 2000

7-15

SCt300 BTS Hardware Installation, ATP and FRU Procedures

PRELIMINARY

Objective

The objective of this procedure is to configure the BTS and establish

communication sessions between the LMF and BTS. This procedure

consists of:

1. Creating a named hyperterminal connection for MMI

communication

2. Establishing an MMI communication session

3. Programming customer operating channel

4. Verifying BTS synchronization mode

5. Verifying DPLL tracking

Creating a Named

HyperTerminal Connection for

MMI Communication

Confirming or changing the configuration data of certain BTS Field

Replaceable Units (FRU) requires establishing an MMI communication

session between the CDMA LMF computer and the FRU. Using features

of the Windows operating system, the connection properties for an MMI

session can be saved on the CDMA LMF computer as a named Windows

HyperTerminal connection. This eliminates the need for setting up

connection parameters each time an MMI session is required to support

optimization.

Once the named connection is saved, a shortcut for it can be created on

the Windows desktop. Double–clicking the shortcut icon will start the

connection without the need to negotiate multiple menu levels.

Follow the procedures in Table 7-5 to establish a named HyperTerminal

connection and create a Windows desktop shortcut for it.

Table 7-5: Create a HyperTerminal Connection

Step Action

1 From the Windows Start menu, select:

Programs > Accessories

2 Select Communications, double click the Hyperterminal folder, and then double click on the

Hypertrm.exe icon in the window which opens.

NOTE

S If a Location Information Window appears, enter the required information, then click on the

Close button. (This is required the first time, even if a modem is not to be used.)

S If a You need to install a modem..... message appears, click on NO.

3 When the Connection Description box opens:

– Type a name for the connection being defined (e.g., MMI Session) in the Name: window,

– Highlight any icon preferred for the named connection in the Icon: chooser window, and

– Click OK.

. . . continued on next page