Installation Instructions

BTS Preparation – continued

DEC 2000

7-5

SCt300 BTS Hardware Installation, ATP and FRU Procedures

PRELIMINARY

Removing Diagnostic Access

Cover Procedure

The screws are captivated. Do not attempt to remove them

from the cover.

NOTE

Table 7-1: Procedure for Removing Diagnostic Access Cover

Step Action

1 Using a T20 Torx tamper bit, loosen the two tamper resistant

M4 screws holding the cover. See Figure 7-4.

2 Gently tap the cover to loosen if required.

3 Remove the cover and set inside a secure place.

NOTE

The 19 MHz and 2 SEC connectors should not be terminated

with a 50 ohm terminator.

Figure 7-4: How To Remove The Diagnostic Access Cover (Microcell shown)

SCREWS IN DIAGNOSTIC

ACCESS COVER ARE CAPTIVE