Installation Instructions

Attaching the Short Duration Battery to the Unit (optional)
DEC 2000
6-17
SCt300 BTS Hardware Installation, ATP and FRU Procedures
PRELIMINARY
Objective
The objective of this procedure is to attach the short duration battery to
the unit.
Required Tools and Materials
Attaching the battery to the unit requires:
S T30 Torx tamper bit, 1/4–in. hex
S Torque driver wrench, 1/4–in. hex female drive, 0–10 N–M
S Two (2) Screws M6x19 (Motorola Part Number 0387541C03)
Procedure to Attach the
Battery to the Unit
Follow the procedure in Table 6-10 to attach the short duration battery to
the unit. Refer to Figure 6-11.
Table 6-10: Procedure to Attach the Short Duration Battery to the Unit
Step Action
1 Hold the battery in the position shown in Figure 6-11.
2 The two holes at the end of the battery should align with the
mounting holes on the unit. See Figure 6-11.
3 Start but do not tighten the M6x19 screws.
4 Using a T30 Torx tamper bit wrench, 1/4–in. hex female
drive, 0–10 N–M, torque the screws to 5 N–M.
6