Installation Instructions

Attaching Front Fin Cover to Unit

PRELIMINARY

SCt300 BTS Hardware Installation, ATP and FRU Procedures

DEC 2000

6-14

Objective

The objective of this procedure is to attach the front fin cover to the

PicoCell and MicroCell units.

When to Use the Fin Covers

Always use fin covers for an indoor application.

Procedure

Follow the procedure in Table 6-7 to attach the front fin cover to the

unit. Refer to Figure 6-9.

Table 6-7: Procedure to Attach Front Fin Cover to Unit

Step Action

1 Center fin cover on the fins of the unit. See Figure 6-9 for

snap locations.

2 Align snap with center tab on fins.

3 Push fin cover into place.

Figure 6-9: Attaching Front Fin Cover to Unit (Picocell Shown)

PICOCELL FINS

LOCATION OF SNAPS TO ATTACH

FIN COVER TO UNIT