Installation Instructions

Prepare to Leave the Site – continued

DEC 2000

7-65

SCt300 BTS Hardware Installation, ATP and FRU Procedures

PRELIMINARY

Replace Diagnostic Access

Cover

Use a T20 Torx tamper bit to tighten the two tamper–resistant M4

screws holding the cover. Torque to 10 in–lb. Refer to Figure 7-21.

Figure 7-21: How To Replace The Diagnostic Access Cover (Microcell shown)

SCREWS IN DIAGNOSTIC

ACCESS COVER ARE CAPTIVE

Replace Solar Cover

Replace the solar cover. Refer to the “Powering on Unit and Mounting

the Solar Cover” procedure in Chapter 5.