User Manual

6-63
Connecting CBRs to cell (cell wiring)
There are minimal wiring tasks for you to perform, as the CBR simply slides into the pre-
existing wiring when you place the CBR in the cabinet.
The cabinet into which the CBR is installed has a pre-wired harness. This harness supplies
power and Ethernet connectivity to the CBR. After you connect the antenna to the
appropriate connector, the CBR also receives airlink traffic. Finally, the harness supplies an
alarm capability to the CBR, as well as a GPS signal.
Note: Make sure you have made all antenna connections before attempting to transmit. Do
not attempt to transmit before the antennas are connected.