User Manual

6-62 Configuring, Installing, and Using Carrier Infrastructure
Attaching the switch and power supply to the rack
Figure 6.2 shows where the switch and power supply should be installed on the rack, in
relation to the cabinet and CBRs.
Installing the CBRs into the cabinet
To install the CBR in the cabinet:
1 Grasp the CBR by handles on each side of the CBR.
2 Slide the CBR into the cabinet, aligning the guides along the side of the CBR with the
gliders inside the cabinet.
To ensure you align the CBR properly into the pre-installed harness connections, there is a
guide pin on the back of the cabinet that fits into a guide pin opening on the back of the
CBR. This guide pin will help the connectors on the back to align correctly.
3 When the CBR is properly installed and aligned in the cabinet, the plastic latches on the
side of the front plate snap into place.
Note: Always make sure the CBR is slid greater than halfway into the cabinet. A CBR that is
not at least halfway installed in the cabinet could fall out of the cabinet.
Figure 6.2 Location of switch and power supply in rack
CBRs
Power supply
Switch