User Manual

5-58 Configuring, Installing, and Using Carrier Infrastructure
Powering the base station
The base station does not have a power switch. Rather, it receives its power when the UPS,
power supply, and TVS module are connected to the base station through the Ethernet/
power cable.
To connect the base station to a power supply, connect these components in the order that
follows:
1 Connect the base station to the antenna.
2 Connect the GPS to a base station, and use a daisy chain wiring scheme to connect the
other base stations.
3 Connect the base station to the TVS module using the Ethernet/power cable of the
desired length.
4 Use an Ethernet cable to connect the TVS module to the network. Use a standard DC
power cable to connect the TVS module to the power supply.
5 Connect the power supply to the UPS.
6 Connect the UPS to an AC power supply.