User Manual

3-21
Defining zone names
To define zone names:
1 From the AP server’s home page, click Configure.
2 From the Configure page, click the Base Station Configuration link.
3 In the Enter new zones below, comma separated field, type the names of base station
zones. Use commas to separate names.
4 Click Save Zone Changes. The new zone names appear in the Zone column.
Registering with the AP server after Zones defined
After you define zones, the base stations must re-register with the AP server so that the AP
server recognizes the base station as having a correct zone.
To re-register the base station with the AP server:
1 Establish a terminal session with the base station.
a From the Base Station Properties page (see Figure 3.11), click on the IP address of the
base station.
b A terminal session starts, where you can log in to the NNOS.
2 To assign the base station to zone, use the NNOS command “set system location”. This
generates a base station registration record.
3 To save the settings on the base station, type write. The change is written to Flash memory
on the base station.
4 Close the terminal session.
Figure 3.6 Base Station Attributes page
CityCentral
CityNorth
CitySouth
CityEast
CityWest
4.0.0
MK