User's Manual

ix
Operational Cautions
Cleaning and Drying Considerations
This product is not water proof, and exposing the unit to liquids may result in permanent
damage to the unit. If your PCEx25100 interior gets
wet, do not try to accelerate drying with
the use
of an oven or a dryer as this will damage the PCEx25100 and void the warranty.
Instead, do the following:
1. Immediately power off the PCEx25100.
2. Shake excess
liquid from PCE
x25100.
3. Place the PCEx25100 in an area that is at room temperature and has good ai
r flow.
4. Let the PCEx25100 dry for 72 hours before powering on again.
If the PCEx25100 does not work after following the steps
listed above, contact your dealer for
servicing information.
Clean the external
surfac
es of the PCEx251
00 with a damp cloth, using a mild solution of
dishwashin
g detergent and water. Some household cleaners may contain chemicals that could
seriously damage the PCEx25100. Avoid the use of any petroleum-based
solvent cleaners.
Also, avoid app
l
ying liquids directly on the PCE
x251
00.
Nearly every
electronic device is susceptible to electromagnetic interference (EMI) if
inadequately shielded, designed or otherwise configured for electromagnetic compatibility.
Operational Warnings
For Vehicle With Air Bags
Do not place a PCEx25100 in the area over an air bag or in the air bag deployment area. Air
bags inflate with great force. If a PCEx25100 is placed in the air bag depl
oyment area and the
air bag inflates, the PCEx25100 may
be propelled with great force and cause serious injury to
occupants of the vehicle.
Potentially Explosive Atmospheres
Turn off your PCEx25100 prior to entering any area with a potentially explosive atmosphere.
Sparks in a potentially explosive atmosphere can cause an explosion or fire resulting in bodily
injury or even death. The areas with potentially explosive atmospheres referred to above
include fueling areas such as below decks on boats, fuel or chemical transfer or storage
facilities, and areas where the air contains chemicals or particles such as grain, dust or metal
powders, and any other area where you would normally be advised to turn off your vehicle
engine. Areas with potentially explosive atmospheres are often but not always posted.
Blasting Caps and Blasting Areas
To avoid possible interference with blasting operations, turn off your PCEx25100 when you
are near electrical blasting caps, in a blasting area, or in areas posted: “Turn off two-way
radio.” Obey all signs and instructions.