Installation and Operating Manual

14
To use the LEDs to find the strongest service provider
signal:
1 If you have plugged the Ethernet cable into the bottom
of the CPE, disconnect the Ethernet cable now.
2 Make sure the CPE’s power cord is connected to the
CPE and to a power source. If your CPE has power, the
LEDs on the CPE begin to blink on and off.
3 With CPE in hand, stand in front of the window in the
room where you plan to operating the CPE.
To scan for the strongest signal, you will rotate the front
of the CPE in a 180 degree path in front of the window,
much like moving the small hand of a clock to 9:00,
10:30, 12:00, 1:30, and 3:00.