Installation and Operating Manual
Table Of Contents
- Installing and using your CPE device
- Welcome!
- Connecting your CPE to a computer or LAN
- Installation Overview
- Setting up the computer to dynamically receive an IP address
- Windows 95, Windows 98, Windows NT: Setting up the network connection
- Windows 2000: Setting up the network connection
- Connecting the CPE to a Computer or Network
- Connecting the CPE to a computer
- Connecting the CPE to a network
- Supplying Power to the CPE
- Finding the Strongest Service Provider Signal
- Using the Software-Assisted Method to Find the Strongest Signal
- Using the LEDs to find the Strongest Service Provider Signal
- Troubleshooting
- LEDs that don’t blink, but rather chase
- The LEDs on the CPE blink more slowly than normal
- You receive a dialog box indicating that you cannot connect to your service provider
- I can successfully contact my service provider at home, but not at work or at a friend’s house
- If You have Problems Getting Connected
- Congratulations!
9
• Software-assisted method (available for Windows
operating systems only)
• LED method (available for any operating system)
Regardless of the method you use, you need to understand
which sides of the CPE are its front, back, top, and bottom.
Figure 4 illustrates the CPE sides.
4A
USING THE SOFTWARE-ASSISTED METHOD TO
F
IND THE STRONGEST SIGNAL
To use the software program to help you search for the
strongest service provider signal in your area:
1 Locate the software CD supplied with your CPE. Insert
the CD into your computer’s CD drive and run the
Setup program.
2 After the software installs, run the program. The CPE
Figure 4: CPE sides
backfront
top
bottom