Installation and Operating Manual
Table Of Contents
- Installing and using your CPE device
- Welcome!
- Connecting your CPE to a computer or LAN
- Installation Overview
- Setting up the computer to dynamically receive an IP address
- Windows 95, Windows 98, Windows NT: Setting up the network connection
- Windows 2000: Setting up the network connection
- Connecting the CPE to a Computer or Network
- Connecting the CPE to a computer
- Connecting the CPE to a network
- Supplying Power to the CPE
- Finding the Strongest Service Provider Signal
- Using the Software-Assisted Method to Find the Strongest Signal
- Using the LEDs to find the Strongest Service Provider Signal
- Troubleshooting
- LEDs that don’t blink, but rather chase
- The LEDs on the CPE blink more slowly than normal
- You receive a dialog box indicating that you cannot connect to your service provider
- I can successfully contact my service provider at home, but not at work or at a friend’s house
- If You have Problems Getting Connected
- Congratulations!
6
window, click OK. On the remaining open window,
click OK again.
2
CONNECTING THE CPE TO A COMPUTER OR
N
ETWORK
You can connect the CPE directly to a computer, or you
can connect it to a small office/home office (SOHO)
network.
• If you are directly connecting the CPE to your com-
puter, go to step 2A.
• If you are connecting the CPE to a network, go to
step 2B.
2A
CONNECTING THE CPE TO A COMPUTER
Use the supplied Ethernet cable to connect the CPE to
your computer, as follows:
1 On the bottom of the CPE, locate the CPE Ethernet
jack. Plug one end of the Ethernet cable into the CPE