User Manual

7-70 Configuring, Installing, and Using Carrier Infrastructure
Figure 7.4 shows the location of the power connection on the bottom of the cabinet.
Table 7.1 describes the power connectors that you must use with the cabinet. If the exact
connector is not available, use a connector that is similar to the one listed
To connect power:
1 Perform one of the following:
• If you are using a power supply from or recommended by Nextnet Wireless, plug that
connector into the NextNet Wireless supplied power connector on the bottom of the
cabinet.
• If you are using a different power supply, connect it to the 50-amp power connector,
found on the bottom of the cabinet.
2 If desired, connect a battery backup power supply to the battery backup connector.
Figure 7.4 Power connections on bottom of cabinet
50 Amp power
connector (optional, for
customer-provided
power supply)
30 Amp battery backup
connector
NextNet Wireless
preferred power supply
connector
DO NOT
DISCONNECT.
Pre-wired power and
NextNet Wireless
preferred power supply
Table 7.1 Connector type to use with cabinet connectors
Connector Connector type to use with
NextNet Wireless preferred power supply
connector
Molex #39-01-2180
50 Amp power connector (optional, for
customer-provided power supply)
Molex #42816-0212
30 Amp battery backup connector Phoenix #1848892