User Manual

7-67
Connecting RMBs to cell (cell wiring)
There are minimal wiring tasks for you to perform, as the RMB simply slides into the pre-
existing wiring when you place the RMB in the cabinet.
The cabinet into which the RMB is installed has a pre-wired harness. This harness supplies
power and Ethernet connectivity to the RMB. After you connect the antenna to the
appropriate connector, the RMB also receives airlink traffic. Finally, the harness supplies an
alarm capability to the RMB, as well as a GPS signal.
Note: Make sure you have made all antenna connections before attempting to transmit. Do
not attempt to transmit before the antennas are connected.