User Manual

5-36 Configuring, Installing, and Using Carrier Infrastructure
6 Specify the SNMP community name. A community is a logical relationship between an
SNMP agent and one or more SNMP managers. The community has a name, and all
members of a community have the same access privileges.
To specify the community that will have read privileges:
set snmp read community {name}
To specify the community that will have write privileges:
set snmp write community {name}
For both parameters, {name} specifies the name of the community.
7 To allow the ability to configure parameters through SNMP access:
set snmp access enabled
8 If you changed the settings for the set snmp state, write your changes to Flash memory
and then restart the base station.
a At the NNOS command prompt, type
write .
b At the next NNOS command prompt, type
reboot .
Configuring SNMPc 5.0 for use with Expedience base
stations
If you are using the network management application SNMPc 5.0 from Castle Rock, change
the default community name of base stations.
1 Open the SNMPc 5.0 application and select a base station.
2 Within the application, use the set community command to set the base station’s
community name to “public”.
Note: The default community name is netman.
3 Repeat step 2 for each base station you want to manage.