User Manual

3-22 Configuring, Installing, and Using Carrier Infrastructure
Registering with the AP server after Zones defined
After you define zones, the base stations must re-register with the AP server so that the AP
server recognizes the base station as having a correct zone.
To re-register the base station with the AP server:
1 Establish a terminal session with the base station.
a From the Base Station Properties page (see Figure 3.11), click on the IP address of the
base station.
b A terminal session starts, where you can log in to the NNOS.
2 To assign the base station to zone, use the NNOS command “set system location”. This
generates a base station registration record.
3 To save the settings on the base station, type write. The change is written to Flash memory
on the base station.
4 Close the terminal session.
5 To verify that the base station’s zone name is correct, refresh the web browser.
Defining ISPs
To define ISPs:
1 From the AP server’s home page, click Configure.
2 On the Configure page, click the ISP Management link.
Figure 3.7 ISP Management page
174.192.047.1
174.167.123.1
4.0.0
MK