User Manual
Table Of Contents
- Preface Overview
- About this guide
- Additional documentation
- Typographical conventions this guide uses
- Where to go for more help
- Chapter overview
- System overview
- Installation overview
- Planning the installation
- Chapter overview
- Before you begin
- Using Term or Telnet to help configure base stations
- Setting base station configuration parameters
- Chapter overview
- Before you begin
- Cell wiring
- Base station connectors
- Mounting the base station
- Connecting the antenna to the base station
- Connecting the GPS equipment to a base station
- Connecting to the backbone network
- Powering base stations
- Verifying system operation
- Appendix overview
- Appendix overview
A-30 Configuring, Installing, and Operating Base Stations
Base station power/Ethernet
cable. Depending on your needs,
the following lengths are
available:
Base station power/Ethernet
cable, 10 ft.
597-6013-0010
Base station power/Ethernet
cable, 25 ft.
597-6013-0025
Base station power/Ethernet
cable, 100 ft.
597-6013-0100
Base station power/Ethernet
cable, 200 ft.
597-6013-0200
Base station site power supply kit,
which includes:
123-0100-0140
3 power supply modules 420-0100-0500
19 inch rack mounting chassis 420-0100-0501
Cable alternatives
Base station to GPS receiver,
25 ft.
597-6011-0025
Base station to GPS receiver,
100 ft.
597-6011-0100
Base-to-base daisy chain
cable, 3 ft.
597-6012-0003
Base-to-base daisy chain
cable, 10 ft.
597-6012-0010
Table A.1
Parts list
Component Part number