User Manual

Table Of Contents
3-27
Powering the base station
The base station does not have a power switch. Rather, it receives its power when
the UPS, power supply, and TVS module are connected to the base station
through the Ethernet/power cable.
To connect the base station to a power supply, connect these components in the
order that follows:
1 Connect the base station to the antenna.
2 Connect the GPS to a base station, and use a daisy chain wiring scheme to
connect the other base stations.
3 Connect the base station to the TVS module using the Ethernet/power cable of
the desired length.
4 Use an Ethernet cable to connect the TVS module to the network. Use a
standard DC power cable to connect the TVS module to the power supply.
5 Connect the power supply to the UPS.
6 Connect the UPS to an AC power supply.
Verifying system operation
Before you leave the cell site, make sure the system is operational. To do so:
1 TBD
2 TBD
3 TBD