Installation Instructions

System Requirements for Installation and Operation

42 (43) © Nokia Corporation DN00283911

Nokia Proprietary and Confidential Issue 2 DRAFT 1 - en

Note

Table 9. Recommended tools and usage

Additional tools/equipment include:

• 2 x radio phones for communicating when testing the fibre optic cable

splicing

• Spirit level for checking the horizontal level of the MU and RU

• Tape measure

• Hammer

• Screwdrivers

• Crimping tool for assembling the power supply cable connector

A set of tools needed for assembling the cable connectors is available from Nokia.

• Cable stripper for assembling the power supply cable connector

• Power meter, including a 50 Ohm, 30 W, DC - 2GHz terminator and a set

of 7/16 N male and female RF adapters

The power meter should be a GSM 900/1800 or CDMA/TDMA/GSM 800/1900,

dual band, fully portable RF power meter with: high resolution, analogue/digital

readout and dBm/watt conversion capability

• Labels for labelling the origin and destination of cables

• Screwdriver for assembling the AC cable connector

• Ladder (depending on circumstances on site)

• Scaffolding, if working at height

• Cutter

• Wrenches

• Dynamometric wrench

• Scissors

• Allen keys, sizes 4 and 6 for fixing the MU to the mounting frame

• T20 Torx torque driver for removing and tightening the MU cover top

retaining screws (optional)

• Centre punch for marking hole locations in wall (optional)

• Drill with correct bits for the mounting position and location (if required)

• Extra lighting for splicing work area

• Table for splicing machine

• Set of Allen keys